I would like to hire a PCB Layout Designer

I have a circuit design currently in the form of a working prototype in strip board form that I need to turn into a 2 inch by 2 inch square printed circuit board. I need someone to create a correct pcb file that I can upload to pcb manufacturers. The circuit is fairly straight forward ward. The pcb must connect a 36 pin micro controller chip to several sensors. The company we will be using to manufacturer the board you design has the following file requirements: -All layers must be registered (all same offset) -274x Gerber files only -25 mils minimum radius for board ouline. -Board outline provided, ideally in a separate layer (if no outline provided a rectangular shape will be created at our discretion). -No data outside board outline -No internal routing/slots -6 mil trace and space minimum -15 mil minimum hole size (All holes will be plated if specifications not provided) -Scored or tabbed arrays are not allowed -Plated/non-plated slots are not supported. Plated slots will run with a single drill hit the size of the width of the slot (not the length). -1 design per a file set/order - Do not forget to embed a tool list in your Excellon drill file, or provide one in a separate text file. Common file extensions for Tool Lists are .tol and .rep. -A minimum of .005" annular ring for vias required. -A minimum of .007" for component holes required. -Vias with connecting traces must have a pad that is 10 mils larger than their drill. -Component through holes with electrical connections must have a pad that is 14 mils larger than their drill. -Tooling holes with no electrical connections may have 0 mil annular ring. -A minimum of 10 mil spacing (edge to edge) between drilled holes that have a diameter less than 65 mils is required.