Atmega Micro Controller Programming

HI I am experienced electronics engineer with more than 14 years of experience. I have read the details and have worked with CAN before. Please get in touch to discuss it further REgards

Hello, I am electronics and embedded systems engineer and TA as well. I can interface your Atmega with the PC through serial and a usb converter then interface the Atmega to other devices over a can bus. Contact me to discuss the details in depth. Regards.

I read your project description , "C programming Micro Controller" carefully. I got your point I can do this project for you perfectly. I am more helpful in the success of each other and are careful in establishing a long-term partnership with the clients and customers. Please leave a message on my chat so we can discuss the budget and deadline of the project. Best Regards: Aqeel Ahmed

Hello I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design So let's discuss your project in chat

Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in: FPGA firmware in VHDL and Verilog for Altera/Actel/Xilinx FPGAs and EEG signal, MCU firmware in C/C++ for ARM, TI, NXP, Atmel, PIC, Arduino; Bluetooth, Bluetooth Low Energy (BLE), and wireless modules programming,, GPS modules, Temperature, Pressure sensors, Metal Detectors, motor drivers, 12V, 24V DC motors, Schematic, PCB Layout: Altium Designer, Component selection, BOM generation, Gerber generation, HVAC, LTE system model, Thermal system design, Matlab/ Simulink, Microcontroller, Modeling, optimization, simulation of building energy systems, and have been working on Industrial Automatics, Prototyping, PCB Design, Development of Electronic systems. Once you share the project, I will have a look & confirm if I can do it. I’m honest, creative and a unique person to carry out your tasks given to me. Leaving your project on our hand is privileged; we'll make sure that the project is done in a perfect way and do our best until you were satisfied. I would love to discuss this project with you and meet your exact requirements. I am confident I can provide you with top-notch materials that will fit your needs. I pride my work on being professional, of the highest quality and always delivered on time

Hello, thank you for your job posting. I read your description about--Microcontroller I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can write the firmware based on Arduino, Raspberry Pi, Pic, Atmega, FPGA, ARM, DSP, PLC and so on. And I can design the circuit by the Altium, Eagle, KiCAD, Allegro & OrCAD, PADs. I provide the services - Gerber files, Netlist generation, BOM generation and 3D Models of PCAD and ECAD. I am also good at AutoCAD, Solidworks. And I can simulate all circuits with Proteus, LT-spice, Matlab, Simulink, Multisim, and Labview as well. Due to my experience in firmware development, I will bring you the perfect result in time with high quality. I will also give you a detailed explanation of the process. Looking forward to hearing from you soon Thanks

- previous experience in such topics; - eager to discuss a lot in this chat stream; - degree stats / maths;