Punch machine Arduino software
The attached file describes a boxing training aid which provides feedback on the power and speed of a punch thrown by a boxer.
Currently the electronics are entirely analogue, (555s Op Amps DPMs, etc). We are interested in replacing the analogue electronics by an Arduino, (or similar), microcontroller and are seeking quotations for the necessary software.
We think the attached file, together with the information provided below, provides sufficient information to allow bids to be prepared but are happy to answer any questions.
Inputs:
Momentary contact touch switch.
Pressure transducer 0 – 5 V output
Output:
2 off seven segment LED displays
8 ohm loudspeaker. Approximately 500 mW drive required. (Might be replaced with piezoelectric loudspeaker)