casting porosity defect simulation using FEA software

Hi. I can do the job. What software do you prefer me to use? I can send you a similar portfolio with my works. Or make a video and send you a link in personal correspondence. Can you send me a model for simulation. Regards. Kostia!

Hello, I have 15+ years of experience in FEA analysis for - structural integrity, failure modes and manufacturing processes. Wanted to know more on this project…what exactly you are looking. What is the objective? Is that you wanted to simulate the porosity / voided in various cases like partly open, fully submerged with various shape like elliptical / spherical etc. ….what next? Do you want to do any analysis there? OR…do you want to obtained the generation of voids during the manufacturing processes Please clarify Regards Suhas Dhakate

My dissertation project was too similar.

A proposal has not yet been provided

I had three years of experience on casting simulation. I am expert to use MAGMA simulation tool. Regards Jayachandra

Worked extensively on Elastic-plastic, explicit dynamic, kinematic analysis. Have good skills in ANSYS Workbench, LS-DYNA, ADAMS, SolidWorks Motion. Please see my portfolio. I can do this in ANSYS Workbench. Looking forward for your reply.

Need to know more of your project. I can make a simulation using Procast. But sure I need to see your model so I can adjust my bid and timing.