Need help configuring Citrix XENSERVER 6.0. I am trying to setup a server, and I ran into some issues. Need someone knowledgeable to help me out.
I citrix xenserver 6.0 setup. There are two physical NIC cards on the hardware. I want to assign eth0 to 192.168.126.x network and I want to assign eth1 to 192.168.127.x network. There are a total of 4 VMs on this xen server. I want to assign two VMs to the first network and the remaining two to the other two networks. Please see the attached image to get a picture of how I would like to setup.
Thank you!
I run a virtual machine software on my home machine and use a bridge for the networking to the NIC on my machine. From your diagram a bridge can be created onto each interface for each pair of VMs, but you will have to connect the NICs to the same switch for all 4 VMs to be able to talk to each other. I know how to do the bridge commands from the command line, so should have no problem setting them up.
Having more then of 4 years experience in Linux admin and Virtulization. I can complete this for you in 1-2 hours. For more discussion send request on s-k-y-p-e vinnie6669