Arduino Voting
$10-30 USD
Paid on delivery
Components.
1 step motor
3 buttons (1 black, 1 green, 1 red button)
2 leds (Green,Red)
RGB String Led
SD Card for statistic data record
Project:
1- User press 1st black button
1 sec delay
RGB strip gets low which was showing avarage vote color.
Servo turns 90 degree
Green Led Lights up for 15 seconds
Green button gets activated 15 seconds
Red Led Lights up for 15 second
Red button gets activated 15 seconds
( user can not push the black button second time till 15 seconds pass, after that it gets activated)
2- if green button pressed
rgb strip gets green with 5 seconds fade in affect
rgb strip fades out in 5 sec.
after 10 sec. rgb shows avarage color from vote percentage.
2- if red button pressed
rgb strip gets re with 5 seconds fade in affect
rgb strip fades out in 5 sec.
after 10 sec. rgb shows avarage color from vote percentage.
All data has to stroed in sdcard which is a component of ethernet shield. Maintenance guy able to connect to read sdcard over ethernet connection without taking out the sdcard.
Main PLC is arduino uno R3 and ethernet shild which has sdcard also
we moved servo out and put one triger command to its place. So when 1st button pressed 1 pin of the arduino has to give 5v output to the our another plc board.
Technician will not check the sdcard information from internet. He will come near board and connects his ethernet cable to uno for to read data which is stored in sdcard.
Project ID: #8311158
About the project
27 freelancers are bidding on average $135 for this job
Dear sir I have more than 8 years experience in electronic design, please check my profile also please message me so that we can discuss
I am an Electrical Engineer having specialization in Electronics and Control, teaching in Electrical Department FAST National University Pakistan. I am also continuing my MS degree in Electrical Engineering with specia More
i am an electronic engineer with more than 5 years of experience. i can make this program for you and help you set it up. please contact me to discuss details
I can help u ....................................................................................................................................................................................
hello i am understanding your algorithm i am arduino expert ready to finish the code within one day good luck
i have experience in the programming of what you need, low is only because i am new to this website.
i am an post graduate in mechatronics engineering , and i had loads of experience in arduino programming , my post graduation thesis and project done on arduino platform itself.i'll assure you ,i'll complete this proj More
I already programmed the Arduino for this task. It is not difficult. You are using the Arduino UNO?
I am firmware developer with more than 35 years, currently I use in my protocol designs for various instrumentation devices with Wifi application using ATMEL and Microchip with "Stack TCP / IP" and have what you need a More
Hey there, I have done a very good work with arduino uno and arduino mega 2560. I have interfaced DC motors, staper motor, LCD and touch screen. I have handed on express with arduino ide. so I suggest you to contect me More
I have completed my B.E. in etrx. I have been working on Arduino since last 3-4 years. I have done many projects on arduino based on gps,gsm,sensors,etc.I believe ,i can definitely help you with your project.
