Configure Freepbx inbound outboud route

Hello I have a lot of expirience in routing with asterisk. Also least-cost routing (LCR) is the process of selecting the path of outbound communications traffic based on cost. I can do this job for the short time. Best regards, Serg.

Hi. I have 9 years of experience in Open source applications like Asterisk, dialler (VICIdial/GoAutodial) and IPPBX (FreePBX/Elastix). Also I have knowledge in PRI/E1, VoIP, SIP Gateways, GSM/FXO GW etc. I'm new to this freelancing site & already handled one project. You can also contact me on Skype. My ID is - apctelco

Hello Im Sourish, I'm an asterisk, vicidial and linux expert. I have installed more than 30 asterisk servers in last 3 years. I am even an active freepbx community member. I am free to start immediately and can complete within few hours. I will show you some basic freepbx management too. Please refer to my experience with freepbx. I hope you will be satisfied with my work and i have enough experience to complete the project. Please do let me know if i can be a part of this project and i would eagerly wait for your response. Thanks Sourish

Hi Inbound / Outbound routing is a one of the first steps of freePBX configuration I've done it many times, and can help you with other features setup withing the mention bid. I am engineer, not manager, so it is direct contact regards, George

Hi, I am Janko from Serbia and I am Digium Certified Asterisk Administrator, therefore I can help you with your job. This should be a simple task in FreePBX, depending on the number of routes you need to set up.

A proposal has not yet been provided

I can do this for you as requested outbound and inbound route for freepbx. please let me know the route type would be PSTN or SIP based.

we have separate team for Linux and asterisk for projects . so we can configure as per your requirement.

Good morning, I have experience, I work as administrator of infrastructure in a call center. and i mount different platforms of telephony